ROSA - ROSETTA1095080 – EN 23The wood is not a fuel, which allows a continuous operation of the appliance, as consequence the heating all over thenight is not possible.Variety Kg/mc KWh/Kgmoistness 20%Beech 750 4,0Oak 900 4,2Elm 640 4,1Poplar 470 4,1Larch* 660 4,4Spruce* 450 4,5Scots pine * 550 4,4*RESINOUS WOOD NOT SUITABLE FOR THE BURNINGWARNING: The continuous and protracted use of aromatic wood (eucalyptus, myrtle etc.) quickly damagesthe cast iron parts (cleavage) of the product.9. LIGHTINGIMPORTANT: The first time that the appliance is lit, there will be an odour given off (due to the drying of theadhesives of the junction chord), which disappears after a short use. It must be ensured, in any case, agood ventilation of the environment. Upon the first ignition we suggest loading a reduced quantity offuel and slightly increasing the calorific value of the equipment.To perform a correct first lighting of the products treated with paints for high temperature, it is necessary to know thefollowing information:• the construction materials of the involved products are not homogeneous, as matter of fact there aresimultaneously parts in cast iron, steel, refractory material and majolica;• the temperature to which the body of the product is subject is not homogeneous: from area to area, variabletemperatures within the range of 300°C - 500 °C are detected;• during its life, the product is subject to alternated lighting and extinguishing cycles in the same day, as well as tocycles of intense use or of absolute standstill when season changes;• the new appliance, before being considered seasoned has to be subject to many start cycles to allow all materialsand paints to complete the various elastic stresses;• in detail, initially it is possible to remark the emission of smells typical of metals subject to great thermal stress, aswell as of wet paint. This paint, although during the manufacture it is backed at 250 °C for some hour s, mustexceed many times and for a given period of time the temperature of 350 °C before becoming completelyembedded in the metallic surfaces.Therefore, it is extremely relevant to take these easy steps during the lighting:1) Make sure that a strong air change is assured in the room where the appliance is installed.2) During the first starts, do not load excessively the combustion chamber (about half the quantity indicated in theinstructions manual) and keep the product continuously ON for at least 6-10 hours with the registers less openthan the value indicated in the instructions manual.3) Repeat this operation for at least 4-5 or more times, according to your possibilities.4) Then load more and more fuel (following in any case the provisions contained in the installation booklet concerningmaximum load) and, if possible, keep the lighting periods long avoiding, at least in this initial phase, short ON/OFFcycles.5) During the first starts, no object should be leaned on the appliance and in detail on enamelled surfaces.Enamelled surfaces must not be touched during heating.6) Once the «break-in» has been completed, it is possible to use the product as the motor of a car, avoiding abruptheating with excessive loads.To light the fire, it is suggested to use small wood pieces together with paper or other traded lighting means. It isforbidden to use any liquid substance as for ex. alcohol, gasoline, oil and similar.The openings for air (primary and secondary) must be opened together, the smoke register is to be adjusted for thecooker function, i.e. the command bar must be pushed to the back of the cooker (the eventual butterfly valve which isfound on the exhaust smoke pipe is also to be opened).