Termo ISOTTA – DSA20 7199701 Rev.05 – EN2. TECHNICAL DESCRIPTIONLa Nordica thermoheating stoves are suitable for heating homes using a centralised heating system made up fromradiators or heat convectors entirely or partially replacing the traditional gas or diesel oil boiler. They are ideal forholiday apartments and week-end homes or as auxiliary heating throughout the entire year.Wooden logs are used ad fuel.The fireplace is found inside the boiler, is built in 4 mm thick steel and is reinforced using welded nails. The water inthe heating system circulates in the boiler, which absorbs the heat produced in the fireplace.A swivelling, removable grid is found inside the fireplace.The hearth is equipped with a panoramic door with ceramic glass (resistant up to 700 °C). This allows a wonderfulview on the burning flames and avoids any possible output of sparks and smoke.The heating of the environment is made:a) radiation: the heat is radiated into the environment through the panoramic window and the hot externalsurfaces of the thermoheating stove;b) by conduction: radiators or heat convectors of the centralised system fed by hot water produced by thethermoheating stove itself.The thermoheating stove has regulators for primary and secondary air, with which the combustion air is adjusted.PRIMARY air controlWith the primary air control (Picture 1 A) is adjusted the passage ofair through the ash drawer and the grate in the fuel direction. Theprimary air is necessary for the combustion process. The ashdrawer must be regularly emptied, so that the ash does not obstructthe primary air entry. Through the primary air the fire is also keptalive.During wood combustion, the register of primary air must beopened only for a while, because otherwise the wood burns fastand the stove may overheat. For the correct arrangement, see thetable on chapter 10.SECONDARY air controlOver the door of the hearth there is the secondary air control(Picture 1 B). This regulator must be open (the lever must bemoved to the right), especially for wood combustion, so that un-burnt carbon does not undergo a post-combustion. See chapter 10.Through this register it is possible to adjust the power of the stove.Leaving it slightly open, according to the flue of the chimney, it ispossible to keep the glass clean.3. RULES FOR INSTALLATIONInstallation of the thermo stove and auxiliary equipment in relation to the heating system must comply with all currentStandards and Regulations and to those envisioned by the law.Installation relating to the connections of the system, commissioning and the check of the correct functioning must becarried out in compliance with the regulations in force by authorised professional personnel with the requisitesrequired by the law, being national, regional, provincial or town council present in the country within which theappliance is installed, besides these present instructions.Installation must be carried out by authorised personnel who must provide the buyer with a system declaration ofconformity certificate and will assume full responsibility for final installation and as a consequence the correctfunctioning of the installed product.NORDICA S.p.A. cannot be held responsible for lack of respect for such precautions.Before installation, accurately wash the pipes of the system in order to remove any residuals that could compromisethe correct functioning of the appliance.IMPORTANT:a) In case of water leaking, close the water supply and promptly warn the after sales technical service;b) The system working pressure must periodically be checked.c) If not using the boiler for a long period of time, it is recommended that the after sales technical service iscontacted to carry out at least the following operations:- close the water taps of both the thermal system and the domestic hot water system;- empty the thermal system and the domestic hot water system if there is risk of freezing.La Nordica S.p.a. declines all responsibility for damage to objects and/or injury to persons caused by thesystem. Moreover, it is not liable for the product that has been modified without authorisation and also forthe use of non-original spare partsPicture 1ABFlat grate