TERMOROSA READY - DSA26 7097503 - IT - EN - DE - FRLANGUAGEBUZZERON - OFFDISPLAY10 - 100%TECHNICALSETTINGS SETTINGS FACTORYCODE 44SET DEGREES°C- FITALIANOENGLISHFRANCAISESPANOLDEUTSHTEST OUTPUTSSYSTEMPR01 CIRCULATOR 1 Threshold OUT 1 (55- 65°C)Default = Heating device 60°CPR02 CIRCULATOR 1 Delta OUT 1 (1 - 5°C)Default = 5°CTEST OUT 1TEST OUT 2TEST OUT 3STATUS Stove I1= xx°C (H 2 O probe)I2= xx°C ( PUFFER probe)I3= xx°C ( BOILER probe)I4= On / Off (Flow switch)PR11 BOILER ( On / Off )PR09 SET BOILER Max ( 47 - 70°C )PR10 SET BOILER Min ( 30 - 46°C )PR11 PUFFER ( On / Off )PR12 thermal differential to PUFFER On (5 - 12°C) Default = 7°CPR13 thermal differential to PUFFER Off (3 - 8°C) Default = 5°CPR03 CIRCULATOR 2 Threshold OUT 2 (65 - 75°C)Default = Heating device 70°CPR04 CIRCULATOR 2 Delta OUT 2 (1 - 5°C)Default = 5°CPR05 ANTIFREEZE Threshold (2 - 10°C)Default = 5°CPRODUCTCODE 335.2. FLOW CHART - MENU5.3. EXTRA FUNCTIONSThe TECHNICAL SETTINGS menu can be used to:Press key T4 to enter the SYSTEM menu. Press the T4 key to enter the BOILER and PUFFER sub-menu, use buttons T2 / T3. Press T4to confirm the selection.5.3.1. THREE-WAYS VALVEThe three-ways valve is activated when the controller is “ON” , when the BOILER is ON (PR08=ON) and the temperature measured bythe I1 water temperature probe exceeds the selected one, default OUT1=60°C (PR01) delta OUT1=5°C (PR02).See Chapter 5.4 and schema 5.5.3.2. BOILER ActivatedThe BOILER is activated when the controller is “ON” .The BOILER is ON (PR08=ON) when the temperature measured by the I3 water temperature probe (OPTIONAL / L= 2 meters) exceedsthe selected one, SET BOILER MIN=30°C (PR10) MAX=60°C (PR09).See Chapter 5.4 and schema 3, and 5.5.3.3. PUFFER ActivatedThe PUFFER is activated when the controller is “ON” .The PUFFER is ON (PR11=ON) when the difference between the temperature, measured by the I2 water temperature probe (OPTIONAL /