LAI Games Let’s Bounce Operator's Manual

Contents

LAI Games Let’s Bounce Operator's Manual Manual pdf 40 page image

40COUNTERSCounters will increment for each coin inserted and each ticket paid out. Counters are underfirmware control and are not directly connected to the mechanisms.BUTTONSPress the green SERVICE/BACK button to issue a service credit from attract mode. Press and hold thegreen SERVICE/BACK button to enter temporary Free Play Mode. This will remain in place untilmachine power is reset.Press the red TEST/ENTER button to enter the operator menu from attract mode.When in the operator menu, use four up/down/left/right buttons to navigate through the menu.VOLUME KNOBUse to adjust the speaker’s sound level.COIN MECHANISM / BILL ACCEPTOR / CARD SYSTEMCredits can be inserted via a coin mech, bill acceptor and/or card system connection. All interfacesare located inside the front coin doors.TICKET MECHSTickets won are paid out from two ticket mechs. Being a 2-player game, tickets are paid out on themech corresponding to the player. Player 1 tickets are paid out on ticket mech 1 and player 2 ticketsare paid out on ticket mech 2. The exception being when the “Card System” game setting is set toON. If a 2-player game is played by crediting only a single player position then all tickets are paid outon that players ticket mech.PLAYFIELD FUSES – FB214Each tile on the playfield receives an independent power and data connection. Each tile is fused bythe FB214 PCBs which are located behind the side panel.GAME BOARD – FB216The FB216 is the main control board for the game. It contains the application firmware and outputdrivers to control the lamps, displays and tiles.SOUND BOARD – FB106The FB106 is the sound driver board containing the sound files and amplifier. Volume is adjusted bythe potentiometer on the operator panel.BALL DISPENSERThe ball dispenser is a 2-stage mechanism consisting of a ball lifter and a ball gate.The lifter is a rotating plate to lift the ball to the ball gate. Balls are counted by the FB84 IR SensorPCB.The ball gate is used to hold the balls before dispensing them to the player. Gate position is detectedby the FB165 sensor PCB.