LAVAMAT LS 84840 User Manual

LAVAMAT LS 84840 User Manual Manual pdf 16 page image

Cancelling a programmeTurn the selector dial to and then in the new selected programme.Press the button 5 to cancel the programme which is running.Now press the button 7 to start the new programme.Opening the door after the programme has startedFirst set the machine to Pause by pressing the button 7.• If the display says that the appliance is in pause, the door can be opened• If the display says alternately that the appliance is in pause and the door is locked, thismeans that the machine is already heating, that the water level is above the bottomedge of the door or that the drum is turning: in this case the door can not be opened• If you cannot open the door but you need to open it you have to switch the machine offby turning the selector dial to . After about some minutes the door can be opened(pay attention to the water level and temperature!).After closing the door, it is necessary to select the previous programme again and to pressthe button 7, the machine will resume the programme from the point where it had beeninterrupted.At the end of the programmeThe machine stops automatically. The pilot light of the button 7 goes off, a staticappears on the display and the acoustic signal sounds for some minutes.If the RINSE HOLD or NIGHT CYCLE option has been selected, the pilot light of the button 7goes off, the display says that the door is locked and the RINSE HOLD option has been se-lected, the door is blocked to indicate that the water must be emptied out.Before you empty out the water, the drum continues to run at regular intervals until thewater draining.Please follow the below instructions to empty out the water:• turn the programme selector dial to /OFF,• select the DRAINING or SPINNING programme and confirm it by pressing button 5,• reduce the spin speed if needed, by means of the relevant button,• press the button 7,• when the programme has finished the display shows a static and the display saysthat the programme is finished. The door can be opened.Turn the programme selector dial to /OFF to switch the machine off. Remove the laun-dry from the drum and carefully check that the drum is empty.If you do not intend to carry out another wash, close the water tap. Leave the door open toprevent the formation of mildew and unpleasant smells.Stand by : once the programme has finished after a few minutes the energy saving systemwill be enabled. The brightness of the display is reduced. By pressing any button the appli-ance will come out of the energy saving status.16Downloaded From WashingMachine-Manual.com Manuals