La Crosse Technology WS-2814U-IT Operation Manual

Also see for WS-2814U-IT: Operation manual

La Crosse Technology WS-2814U-IT Operation Manual Manual pdf 9 page image

P a g e | 9SETUP TROUBLESHOOTING: If the sensor data fails to display for any of the outdoor sensorswithin 10 minutes, (“- - -“are displayed), remove the batteries from all units for 1 minute and startthe Setup procedure again at Step 1.FUNCTION BUTTONSSET Hold for 3 seconds to enter the SET mode, where the following can be changed: LCDcontrast, Manual time setting, 12/24 hour time display, Date setting, °F/°C temperatureunit, Wind speed unit, Rainfall unit, Pressure unit, Relative pressure reference setting,Weather tendency threshold setting, Storm warning threshold setting, Storm Alarm On/Off setting, Wind direction display type, and Factory reset Press to toggle between the display of Mode 1 or Mode 2:o Mode 1: "Wind speed + outdoor temp + 24 hr. pressure history graph"o Mode 2: "Gust + Dew Point temp + 72 hr. pressure history graph " In the weather alarm setting mode, press to switch the weather alarm On / Off In the weather alarm setting mode, press and hold to adjust the weather alarm value Stop the weather alarm when ringing▲/DATE Press to toggle between the display of seconds or date in the time display Press to increase the level of different settings in SET mode Press and hold to re-learn the thermo-hygro sensor synchronization Press to reset the MIN/MAX record when in MIN/MAX display mode Stop the weather alarm when ringing▼/RAIN Press to switch the rainfall display mode: Total, 1h, 24h, week, month Press to decrease the level of different settings in SET mode Synchronize the display with the PC (see Heavy Weather Pro Software User’s Guide)(must use usb stick). Stop the weather alarm when ringingALARM Press to enter the time alarm and weather alarm setting mode Confirm particular alarm setting Press to exit the manual setting mode