La Crosse Technology WS-7095U Instruction Manual

Contents

La Crosse Technology WS-7095U Instruction Manual Manual pdf 19 page image

19C. HARD RESET OF EEPROM WEATHER CENTER MEMORYNote: This is to be used if there are problems with transmission, or ifthe rainfall history bar graph needs to be cleared.1. Remove the batteries and wait 30 seconds. (This will also reset theRainfall Quantity Totals).2. Checking the polarity, install batteries.3. During the brief 2 seconds that all LCD screens light up,simultaneously press and hold the MOON and MIN/MAX buttons.“267” (the default rain multiplicator setting) will appear in LCD 1.The “7” will be flashing.If “267” does not appear, it will be necessary to set the manuallyset the digits. Use the CH/+ button to change the digit, and theSET button to select the digit to be changed.4. Press the SET button two times. (The 2 should flash).5. Hold the SET button down until the air pressure (in hPa) brieflyflashes in LCD 4. “LCD 7” will flash in LCD 2 for 15 seconds.6. Do not press any buttons while the Weather Center searches fortransmission signals.7. Follow Program Mode for set-up procedures.VII. ADDING MORE SENSORS (optional)The WS-7095U can receive signals from up to three Sensors. TheSensor model(s) that you choose will come with their own set ofinstructions—follow those instructions for a complete guide to setting up.Following are some brief instructions for the basic set-up of additionalsensors with the WS-7095U. Additional sensors can be purchasedthrough the same dealer as this Weather Center, or by contacting LaCrosse Technology directly (contact information can be found at the endof this manual). A TX4U will monitor temperature and humidity (it isthe same model that comes with the WS-7095U), a TX3U will monitortemperature only, and the TX3UP monitors temperature via a 10 footprobe for use in pools, spas, etc. The TX3 units do not monitor humidity,thus when they transmit their information to the Weather Center dashes“- -” appear in the Humidity Display.Note: When setting up multiple sensors it is important to remove thebatteries from all existing units in operation, then to insert batteries firstinto all the sensors, and in numeric sequence. Second install batteriesinto the Weather Center. Transmission problems will arise if this is notdone correctly and if the total time for set-up exceeds 6 min.