La Crosse Technology WS-7391UD Instruction Manual

Also see for WS-7391U: Instruction manual Instruction manual

Contents

La Crosse Technology WS-7391UD Instruction Manual Manual pdf 10 page image

10II. Time SettingNote: This is only necessary if you do not wish to wait for theWWVB reception. All manual set data will be over-ridden by thereception of the WWVB signal based on the time zone selected.1. Press and hold the “SET” button (on the back of theclock) for 2 seconds or until “12h” or “24h” flashes.2. Press and release the “SET” button again, the hourwill flash.3. Press and release the “+” button to advance the hour.Note: In 12h mode “PM” will appear to the left of thetime during PM hours. If the time is not within the PMhours nothing will be displayed. Be sure to set the time tothe correct AM/PM time to ensure automatic reception.4. Press and release the “SET” button, the digits thatrepresent the minutes will flash.5. Press and release the “+” button to advance theminutes.6. Press and release the “SET” button to confirm andadvance to the time zone setting (skip step 1 and 2 insection III if continuing).III. Time Zone SettingThe default (factory set) time zone is EST (Eastern Standard Time)1. Press and hold the “SET” button for 5 seconds oruntil “12h” or “24h” flashes.2. Press and release the “SET” button three more times,“EST” will flash (or other time zone if changedpreviously).