La Crosse Technology WS-7391UD Instruction Manual

Also see for WS-7391U: Instruction manual Instruction manual

Contents

La Crosse Technology WS-7391UD Instruction Manual Manual pdf 7 page image

DETAILED SET-UP GUIDEBATTERY INSTALLATIONA. Remote Thermo/hygro Sensor1. Pull the cylindrical rain cover off the remotethermo/hygro sensor.2. Remove the battery cover (located on the backside ofthe remote thermo/hygro sensor, above the mountingpost and bracket).3. Press the arrow and slide the battery cover off.4. Observing the correct polarity install 2 AA batteries.5. Replace battery cover, and place rain cover snuglyonto the remote thermo/hygro sensor.B. Indoor Weather Station1. Remove the battery cover. To do this, insert a solidobject in the space provided at the lower-centralposition of the battery cover, then push up and pullout on the battery cover.BatteryCover2. Observe the correct polarity, and install 2 AAbatteries.3. Replace the battery cover.Note: Immediately after the batteries have been installed, eachLCD (Liquid Crystal Display) will flash, and a tone will sound.Within a few seconds the indoor temperature, indoor relativehumidity, and the weather icons (sun and clouds) will be displayed.If these items are not displayed remove the batteries for 10 secondsand reinstall. If the outdoor temperature is not displayed withinfour minutes, remove the batteries from both units, wait 10seconds, and reinstall. The time will show -:-- and start searchingfor the signal. If it successfully receives the time signal (reception7