La Crosse Technology WS-8035U Instruction Manual

Also see for WS-8035: Instruction manual

Contents

La Crosse Technology WS-8035U Instruction Manual Manual pdf 19 page image

VII. MOUNTINGNote: Before permanently mounting, ensure that the indoor weather station isable to receive signals from the transmitters and WWVB signal at the desiredlocation. To achieve a true temperature reading, avoid mounting the remotethermo/hygro sensor (or any sensor) where direct sunlight can reach the remotesensor. We recommend that you mount the remote sensor on a North-facingwall or under an eve. The sending range of the remote thermo/hygro sensor is300-ft (100m) however obstacles such as walls, concrete, and large metalobjects can reduce the range. Place all units in their desired location, and waitapproximately 15 minutes before permanently mounting to ensure that there isproper reception. If the indoor weather station loses the signal from the remotesensor, it will display the last temperature reading for 15 minutes. After 15minutes of not receiving any signals, the remote temperature will display “- -.-”.A. Mounting the Remote Thermo/hygro SensorThe remote thermo/hygro sensor can be mounted with the use of screwsor by using the adhesive tape.1. Mounting with screwsa. Remove the mounting bracket/receptor from the packaging.b. Place the mounting bracket over the desired mounting surface.c. Through the 2 screw holes of the bracket, mark the mountingsurface with a pencil.d. Where marked, start the screw holes using the providedscrews.e. Remove screws from the mounting surface.f. Align the mounting bracket with the started screw holes.g. Screw mounting bracket onto the mounting surface. Thescrews should be flush with the bracket.h. Fit the mounting post (on the back of the transmitter) into thereceptor of the mounting bracket.19