S1 Dream-T Espresso MachineOwner’s Manual Page 10EGS When enabled the system will release a small amount of water from the grouphead after20 minutes of inactivity. This is more for the European market where they keep ground coffeein the portafilter and the EGS system will keep it from drying out. It can also be enabled to helpkeep the shower screens clean after pulling a shot.Auto Shutdown When enabled the machine will automatically turn itself off after a pre-setperiod of inactivity.Group Cleaning Allows the user to backflush the machine without being stored in the countermenu. This is helpful if you are trying to keep track of how many shots are made on themachine and do not want the backflushing to be counted as a shot.Screensaver The screensaver can be turned on or off. When turned on choose between TheColiseum and the Statue Of Liberty screensavers.Time Update Choose to have daylight savings time activated.Contrast Change the contrast setting of the display.Deact Pres Sens Allows the user to deactivate the pressure sensor for the pump pressureshown on the display. This is only for plumbed in models.Password Allows the user to create a password to block access to the main menu. The defaultpassword is 1-2-3-4. To change a password select modify. After changing the password then itmust be activated in the password menu. If you forget the password then when prompted toenter the password press and hold the button for 5 seconds. The password will be changedback to default and turned off.SW Update Allows the user to update the firmware in their machine. Check our website forfuture updates and improvements.FeaturesDefault Settings Restores the machine to its original factory settings.Factory Allows access to advanced settings. Password J73MZ (See Note Below)Set Calibrate T Calibration of the temperature sensor. Should only be performed by a factorytrained espresso repair shop.Full Power The S1 Dream-T can be set up to work in full power mode. In full power mode themachine draws 20amps of power so a 20 amp receptacle and breaker must be used. If one isnot available then full power mode MUST be turned off.