S1 Dream-T Espresso MachineOwner’s Manual Page 6Power ModesThe S1 Dream-T can be set up to work in full power mode. In full power mode the machinedraws 20amps of power so a 20 amp receptacle and breaker must be used. If one is notavailable then full power mode MUST be turned off.In full power mode the machine is able to heat both boilers at the same time. This is helpful ifyou want to be able to pull a shot and steam milk at the same time.When full power mode is turned off then it is only able to heat one boiler at a time and willalways give priority to the coffee boiler. In this mode it is recommended to pull a shot andsteam milk separately or the machine may lose steam pressure if done at the same time.The power mode can be easily changed in the “Factory” menu.The password for the factory menu is J73MZNote: In version 1.19 the Factory menu has been removed and the full power mode can beaccessed without a password.Warning: Using the machine in full power mode in a 15 amp outlet should never be done.Failure to follow this warning could pose a fire hazard and is not recommended.Information Center With the machine turned on, press and hold the up arrow key. The displaywill then show the serial # and current firmware version. Then press the down arrow key tocycle through the machine settings and alarms. To exit out of the information screen press theok/menu button.FeaturesUser ProfilesThe S1 Dream-T is capable of storing 4 different user profiles. This enables the machine to beprogrammed for different shot volumes, brew temperature, steam boiler water temperature,and hot water delivery method. The machine can easily be switched between different userprofiles to meet the discriminating demands of everyone that uses it. Profiles can also be usedfor different coffee blends that require different temperatures so use your imagination and thepossibilities are endless.Creating User Profiles