LaCie Big Disk User Manual

Also see for LaCie Ethernet Big Disk: User manual Quick install guide User manual Information sheet Specification

LaCie Big Disk User Manual Manual pdf 20 page image

Setting Up Your LaCie Big Diskpage 19LaCie Big Disk User’s Manual2) Disconnect the USB or FireWire cable.3) Connect either the USB or FireWire cable.After switching between interfaces, you may need to quit the application that you were using to access the drive and thenreboot the program. The drive should then be visible and accessible.3.7. Attaching The Drive StandYou can use your LaCie drive in its upright position after installing the drive stand.1) Using the hex key (provided with the drive stand kit), loosen the two screws on the bottom of the foot plate (do not removethe screws) to create a degree of separation between the foot plate and the two rails.2) From the rear of the drive, separate the two rails and slide the larger stand rail into the side groove of your LaCie drive asshown below:3) Slide the stand forward until its rail touches the front of the drive.4) Tighten the two socket screws from the underside of the stand, using the hexkey, until the stand is firmly in place.5) When the stand is mounted, your drive should look like this:BigDiskFW800_UG_030311_4.0 3/11/03 4:49 PM Page 19