LaCie Wireless Space • DESIGN BY NEIL POULTON Basic Install: Setup WizardUser Manual page 223.2. Configuration 1: NAS Ethernet -Wired OnlyIMPORTANT INFO: DO NOT attempt to access the WirelessSpace via the web-enabled Dashboard (see 3.6.1. Dashboard: Ac-cessing) before running the Setup Wizard. During the initial con-figuration, the Setup Wizard must find the Wireless Space on thenetwork. If the Dashboard has made contact with the device, theSetup Wizard will not run since it believes the choice of configurationhas already been made. This could be problematic when attachingthe Wireless Space to a network with a router, server, or Internetprovider that assigns IP addresses using DHCP. Most DHCP serv-ers or devices use the same default settings as the Wireless Spacewhen it is set to a Router configuration, which can create IP addressconflicts on a network.Please see 2. What is the best configuration for my network? beforepreparing your Wireless Space.3.2.1. Wireless Space Setup WizardPreparing for the Setup:✦ Do not connect the Wireless Space to your router, switch, orInternet provider before running the Setup Wizard.✦ Quit the applications running on your computer.✦ If your computer is connected to the router, switch, or Inter-net provider via Ethernet, please disconnect the end from therouter, switch, or Internet provider.1. Connect the power cable to the Wireless Space (see 3.1. Con-nect the Power Supply) and turn the device on (1.5. Power But-ton Functions). In most instances, the light will become solidgreen and turn red during the setup.2. Run the Utilities CD from the computer’s optical disk drive.When prompted, launch the Wireless Space Setup. DO NOTinstall LaCie Network Assistant before running the WirelessSpace Setup.3. Choose your language then select OK. After reading the wel-come screen text, click Continue.4. Select Do not enable Wi-Fi. Click Continue. (Fig. 12)5. Select NAS. Click Continue. (Fig. 13)continued on the next page>>Fig. 12Fig. 13
