User Manual of LV-N9808C8E Series NVR1329.2.8 Configuring Server and HTTP PortsPurpose:You can change the server and HTTP ports in the Network Settings menu. The default server port is 8000 and thedefault HTTP port is 80.Steps:1. Enter the Network Settings interface.Menu >Configuration> Network2. Select the More Settings tab to enter the More Settings interface, as shown in Figure 9. 15.3. Enter new Server Port and HTTP Port.Figure 9. 19 Host/Others Settings Menu4. Enter the Server Port and HTTP Port in the text fields. The default Server Port is 8000 and the HTTP Port is80, and you can change them according to different requirements.5. Click Apply button to save and exit the interface.Note: The Server Port should be set to the range of 2000-65535 and it is used for remote client software access.The HTTP port is used for remote IE access.9.2.9 Configuring EmailPurpose:The system can be configured to send an Email notification to all designated users if an alarm event is detected,etc., an alarm or motion event is detected or the administrator password is changed.Before configuring the Email settings, the NVR must be connected to a local area network (LAN) that maintainsan SMTP mail server. The network must also be connected to either an intranet or the Internet depending on thelocation of the e-mail accounts to which you want to send notification.Steps:1. Enter the Network Settings interface.Menu >Configuration> Network2. Set the IPv4 Address, IPv4 Subnet Mask, IPv4 Gateway and the Preferred DNS Server in the NetworkSettings menu.3. Click Apply button to save the settings.2. Select the Email tab to enter the Email Settings interface.
