Laars mascot ft MFTHW Installation And Operation Instructions Manual

Contents

Laars mascot ft MFTHW Installation And Operation Instructions Manual Manual pdf 61 page image

Mascot FT, Heating Only, BoilerPage 595.6 Status Display ModeStatus display modeDigital Display Status Display Parameter DescriptionO: ot Outdoor temperature Current outdoor sensor temperatureA: In 0-10 V display Current voltage of (0-10V input)b: tt CH target temperature in cascade system Current CH target temperature or CurrentSystem target temperature in a cascade systemC: It CH return water temperature Current CH return water temperatured: Fr FAN speed ( rpm) Current FAN speed ( RPM)E: oP CH supply temperature (Operating temperature) Current heating temperatureF: Eh Exhaust gas temperature Current exhaust gas temperatureH: dHIndirect DHW tank temperature* If temperature sensor is not connectedthen it will display with 0°F (0°C).Current DHW tank temperatureI: oH Overheat water temperature Current Overheat water temperatureL: rt1: PHBurner OperationTimeTime for supply powerL: rt on displayon sub menuUnit : 1000hour2: rh Time for burneroperation Unit : 1hour3: rH Time for burneroperation Unit : 1,000hour4: It Cycle for ignition Cycle : 10 times thedisplayed unit5: IH Cycle for ignition Cycle : 10,000 times thedisplayed unitM:CCSELF Percentage of self units running. Percentage of self units running.ALL Capacity for all operatingcascade unitsPercentage of all cascade units running.This screen shows the overal cascade power output. Therange of this value of boilers communicating with theMasterx 100. For example, if 8 boilers are connected andcommunicating, the maximum cascade power is 800%.Range: 0-100%F1 – F19 Capacity for individual boilers Percentage of each cascade units running.Ex. F1, F2, ….N: StSystem Temperature (cascademode) * If system temperaturesensor is not connected then it willdisplay with 0°F (0°C).Current System Temperature (cascade mode)To change any Status Parameter,Press and Hold Button B to get into the Status Display Mode.Rotate Dial E until you find the Parameter that you wish to change. Tap Dial E to enter that Parameter.Adjust to the setting that you require and then press (tap) Dial E to save and to Exit.B CEA D