Lagler TRIO 900.65.00.100 Operating Instructions Manual

Contents

Lagler TRIO 900.65.00.100 Operating Instructions Manual Manual pdf 27 page image

TRIO 01.04.2015English / EnglischWORKING WITH THE TRIO5.2 CHANGING THE SANDING PLATESDepending on the different types of work to be done you may haveto change the sanding plates.5.2.1 REMOVING THE SANDING PLATES1 Switch off the machine and pull the power plug out of thesocket!2 Release the clamping lever of the handle (fig. 24, 1), pressthe handle forward (fig. 24, 2) and pull the clamping leverback into its prior position (fig. 24, 3).3 While holding on to the handle, carefully tilt the machinebackwards into a horizontal position (fig. 25). Make sure thatthe machine gets to rest on the guide tube (fig. 26, A) and thetwo protective rubbers (fig. 26, B). Make sure the machineis in a safe position! Now the sanding plates are accessiblefrom the front.4 To remove the sanding plate, grasp its edges with your fingersand pull it out of the rubber plugs of the bearing (fig. 27).Never use a screwdriver or a chisel for this job as this couldotherwise cause damage to the plates or the machine!Fig. 27 Grasp the sanding plate edges with your fingersand pull it out of the rubber plugs.Fig. 24 To tilt the machine, release the clamping leverof the handle (1), press the handle forward (2)and pull the clamping lever back into its priorposition (3).5Fig. 26 Make sure that the machine gets to rest on theguide tube (A) and the two protective rubbers (B).Make sure the machine is in a safe position!Fig. 25 Carefully tilt the machine backwards.27