Lami Corporation Lotus-14LK-H Instruction Manual
                        | |
Contents
| 
22 Check temperature and speed settingRefer to P15 of this document to check correct setting of laminate temperature and speed.If temperature and speed are inappropriate, processing may not be done cleanly as shown below. Did you insert a paper too thick?Thickness of paper that can be process by this product, combined with thickness of film, is 1.5 mm. Whena thicker paper is inserted, rollers may not rotate or the product can be damaged. Do not process papersthicker than the regulated thickness.Also, change speed setting when speed setting on the operation panel is 【0】. Is the film or paper rolled into a roller?When a portion of the paper remains in the insertion part, press REVERSE button and pull the paper out.Do not pull too strongly as it can cause failure of the machine.Contact the seller or our company when the paper has completely rolled up into the machine.Processed material does not go in or come outProcessing is not cleanly doneWhen temperature is lowBubbles formed between film and paper.Temperature may be too high.Temperature may be too low.Temperature may be too high.Temperature may be too low.Film turned white.Film was crumpled.Film and paper were not attached.When processing temperature is low, glue on the laminate film does not melt. This fails to make thefilm transparent, resulting in white surface or separation between film and paper.When such symptoms occur, slightly increase processing temperature or slightly decrease processingspeed to adjust the degree of dissolution of glue by applying sufficient heat on paper and film.※ Films on which such symptoms occur cannot be reused.※ Temperature is adjusted by about 5℃.※ If the symptoms are not improved by adjustment, there may be other causes.In this case, contact the seller or our company.When temperature is highWhen processing temperature is high, glue on the laminate film can melt too much to boil and formbubbles or film is excessively softened to crumple.When such symptoms occur, slightly decrease processing temperature or slightly increase processingspeed to adjust the degree of heat on paper and film.※ Films on which such symptoms occur cannot be reused.※ Temperature is adjusted by about 5℃.※ If the symptoms are not improved by adjustment, there may be other causes.In this case, contact the seller or our company. |
Related manuals for Lami Corporation Lotus-14LK-H
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine