Land Pride 322-215M Operator's Manual

Also see for Seed Bed Rollers SBR72: Specifications Owner's manual

Land Pride 322-215M Operator's Manual Manual pdf 11 page image

9Section 1: Assembly & Set-up2/04/12 Model SBR72 Seed Bed Roller 322-215MTable of ContentsRoller Scraper AssemblyFigure 1-43-Point Hook-UpRefer to Figure 1-5 & Figure 1-6:! DANGERCrushing Hazard between tractor and implement. Do notallow anyone to stand between tractor and implement whilebacking-up to an implement. Do not operate hydraulic 3-pointlift controls while someone is directly behind the tractor ornear the Seed Bed Roller.! DANGEREngage parking brake, shut off tractor and remove key beforedismounting from the tractor.! WARNINGSee Figure 3-5 on page 15. Chock front and back of rollerwhen using support stand to prevent unit from rolling andcausing property damage and/or bodily injury.A 3-Point Category I hitch is required. The lower 3-Pointarms of the 3-Point hitch must be stabilized to preventside-to-side movement. Most tractors have sway blocksor adjustable chains for this purpose.1. Slowly back tractor up to the Seed Bed Roller whileusing the tractor’s 3-point hydraulic control to alignthe lower lift arm hitch holes with the clevis lug holeson the Seed Bed Roller.2. Engage tractor park brake, shut tractor engine offand remove key before dismounting from tractor.3. With lower lift arm hitch holes aligned with clevis lugholes, insert hitch pins (#1) through clevis and lowerarm holes. Secure hitch pins with linchpins (#6).4. Align top center link hitch hole with the upper hitchholes and insert 3/4" bolt (#4). Secure bolt withflange lock nut (#5). Draw nut up snug.5. Ensure lower hitch arms are blocked to preventexcessive side movement.257646. Return to the tractor, start engine and slowly operate3-point controls to lift lower arms up just enough toraise support stand (#3) off the ground.7. Engage tractor park brake, shut tractor engine offand remove key before dismounting from tractor.8. Remove support stand (#3), turn it over and reattachit as shown in Figure 1-6 with wire snap lock pin (#7).(Remember: Small notches in stand are mountedtowards the frame tube.)9. Operate 3-point controls up and down to check forclearance between the Seed Bed Roller and tractor.Move or remove tractor drawbar if it interferes withthe Seed Bed Roller.10. Manually adjust one of the two Lower lift arms up ordown to level the Seed Bed Roller from left to right.Manually adjust the length of the top center link tolevel the Seed Bed Roller from front to rear.11. When using a Quick Hitch, attach center hook to1 1/4" spacer (#2) and lower hooks to hitch pins (#1).Tractor 3-Point HitchFigure 1-5Seed Bed Roller Hook-UpFigure 1-62399825781Lower Lift Arm HoleAlignment PositionsTop Center Link HoleAlignment Position