Land Pride 322-215M Operator's Manual

Also see for Seed Bed Rollers SBR72: Specifications Owner's manual

Land Pride 322-215M Operator's Manual Manual pdf 12 page image

10Section 1: Assembly & Set-upModel SBR72 Seed Bed Roller 322-215M 2/04/12Table of ContentsPull-type Hook-up! DANGERCrushing Hazard between tractor and implement. Do notallow anyone to stand between the tractor and implementwhile backing-up to an implement.! DANGEREngage parking brake, shut off tractor and remove key beforedismounting from the tractor.! WARNINGThe Seed Bed Roller hitch has negative weight.! WARNINGSee Figure 3-5 on page 15. Chock front and back of rollerwhen using support stand to prevent unit from rolling andcausing property damage and/or bodily injury.Clevis Hook-up (Tractor drawbar height under 13")Figure 1-7Clevis Hook-up (Tractor drawbar height 13" and higher)Figure 1-82579925783Clevis Hook-upRefer to Figure 1-7 & Figure 1-8:1. Back machine up to the Seed Bed Roller until hole indrawbar hitch is aligned with holes in the clevis hitch.2. Dismount machine properly and insert hitch pin (#3)through hitch clevis holes and drawbar hitch hole.Install hair pin cotter (#4).3. Without removing wire snap lock pins (#5A & #5B):• Unhook wire retainers for both pins (#5A & #5B).• Rotate bottom of support stand (#1) back until hole“A” is in alignment with wire snap lock pin (#5B).• Push support stand onto both wire snap lock pinsand re-hook wire retainers.Ball Hook-upRefer to Figure 1-9:1. Attach customer supplied 2" ball (#8) to the machinepulling the Seed Bed Roller. Tighten nut suppliedwith the ball to correct torque. 2" Ball with 3/4" shank(P/N 890-975C) can be purchased from Land Pride.2. Back machine up to the Seed Bed Roller until the 2"ball is in alignment with ball socket in hitch (#2).Ball Hook-up (Drawbar height 13" and higher)Figure 1-93. Remove retaining pin (#3), pull up on lock latchtrigger (#6) and then pull up on release handle (#4).4. With handle (#4) up, lower hitch (#2) over 2" ball (#8).5. Make sure hitch (#2) is fully on ball (#8) and thenpush handle (#4) down until lock latch (#6) is securedin notch (#7).6. Insert wire retaining pin (#3) in hole “A” and securepin in place with its wire retainer.7. Without removing the two front wire snap lockpins (#5A & #5B):• Unhook wire retainers for both pins (#5A & #5B).• Rotate bottom of support stand (#1) back until hole“A” is in alignment with wire snap lock pin (#5B).• Push support stand onto both wire snap lock pinsand re-hook wire retainers.25776