Land Pride BB4596 Operator's Manual

Contents

Land Pride BB4596 Operator's Manual Manual pdf 18 page image

Section 1: Assembly & Set-upBB4596, BB4510, & BB4512 Pull Type Drag Scraper 306-096M 11/28/1814Table of ContentsLED Light Kit Assembly (Optional With BB4596 & BB4510)Figure 1-11Detail A Detail BAmber Lights “A”Amber Lights “A”Red Light “B”Red Light “B”LED Light Kit OptionRefer to Figure 1-11:LED Light Kit is optional with BB4596 & BB4510 andstandard with the BB4512 model. The lead wiringharness (#4) is equipped with a 7-way round pinconnector. Make sure your tractor is equipped with the7-pin electrical outlet shown in Detail B.1. Lower scraper until unit is resting on the ground.2. Shut tractor down properly before dismounting. Referto “Tractor Shutdown Procedure” on page 16.3. If unassembled, attach magnets (#7) with boots (#8)and self drill screws (#9) to the base of the right-handlight (#6).4. Mount right-hand light (#6) on top of the right-handside of the rear blade panel as shown with red lightfacing back and to the inside.5. Repeat steps 3 & 4 for the left-hand light (#5).NOTE: Amber lights “A” are located outside facingfront and back. Red lights “B” are located insidefacing back only.6. Red wires in connectors (#1A & #1B) are attached topin “D” shown in Detail A. Plug connectors(#1A & #1B) together.7. Amber wires in connectors (#2A & #2B) are attachedto pin “B” shown in Detail A. Plug connectors(#2A & #2B) together.8. Route wire harnesses (#1 & #2) along the top of therear blade panel to enhance module (#3). Plugconnectors at the module together as follows:a. Red wires in connectors (#1C & #1D) areattached to pin “B” shown in Detail A. Plugconnectors (#1C & #1D) together.b. Amber wires in connectors (#2C & #2D) areattached to pin “C” shown in Detail A Plugconnectors (#2C & #2D) together.NOTE: Right-hand wire harness (#1) has a red wireshowing at both ends. Left-hand wire harness (#2)has a yellow wire showing at both ends.NOTE: See Detail A: Connector pins are labeledA, B, C, & D. Match yellow and red wires with samepin letters when attaching wire harness (#1 & #2) tolight assemblies (#5 & #6) and module (#3).