Landa EHW4-2000C Operator's Manual

Also see for EHW4-2000C: Operator's manual

Landa EHW4-2000C Operator's Manual Manual pdf 8 page image

8.941-114.0 • LANDA EHW • Rev. 08/12OPERATOR’S MANUAL PRESSURE WASHER8CAUTIONNever Use:• Bleach, chlorine products and other corrosive chemicals• Liquids containing solvents (i.e. paint thinner,gasoline,oil)• Tri-sodium phosphate products• Ammonia products• Acid-based productsThese chemicals will harm the unit and will damage thesurface being cleaned.CAUTIONNever Use :• Bleach, chlorine products and other corrosive chemicals• Liquids containing solvents (i.e. paint thinner,gasoline,oil)• Tri-sodium phosphate products• Ammonia products• Acid-based productsThese chemicals will harm the unit and will damage thesurface being cleaned.OPERATING INSTRUCTIONSSTEP 1: Connect the high pressurehose quick coupler to the dischargenipple by sliding the quick couplercollar back and inserting the quickcoupler onto the discharge nippleand pushing the quick coupler collarforward to secure it. Secure desiredpressure nozzle into variable pres-sure wand coupler.High PressureHose CouplerSTEP 2: Connect water sup-ply hose (garden hose) to inletconnector. Do not allow acid orabrasives to be pumped throughsystem. Turn on water.GardenHoseInletSTEP 3: Place toggle switch inthe ON position and then pull thetrigger on the spray gun to activate apressure switch which will then startthe machine. The ON position is forauto shut down.STEP 4: Turn the variable pressure control handle clockwiseto increase pressure.Selection of high or low pressure is accompanied by turning thehandle. NOTE: High pressure nozzle must be inserted at end ofwand to obtain high pressure. To apply soap read Detergents &General Cleaning Techniques section.Variable PressureControl Handle TriggerVariable PressureWand (VP)HighPressureNozzleBrass SoapNozzleSTEP 5: To stop machine, releasethe spray gun and machine willautomatically stop in approximately12 seconds. If machine is going tobe unattended for long periods oftime, turn water supply off and placeswitch in OFF position.N O T E : W h e n r e m o v i n g o rreplacing hoses, wand and nozzles,move switch to OFF position, openspray gun to release pressurebefore removing discharge hose.CAUTIONNever Use :• Bleach, chlorine products and other corrosive chemicals• Liquids containing solvents (i.e. paint thinner,gasoline,oil)• Tri-sodium phosphate products• Ammonia products• Acid-based productsThese chemicals will harm the unit and will damage thesurface being cleaned.DischargeNippleToggleSwitch