Landoll VT Plus 7431 Operator's Manual

Contents

Landoll VT Plus 7431 Operator's Manual Manual pdf 37 page image

ASSEMBLY INSTRUCTIONS3-5Leveler Assembly1. Install a hardened steel wear bushing in the leveler Llink (See Figure 3-2.)2. Attach the leveler L link to the front mount of thecenter frame with a 1-8 x 4-1/2 hex head cap screwand hex lock nut.3. With a 1-8 x 4 hex head cap screw and hex lock nutattach the leveler ball joint link to the leveler L link.4. Connect the bottom end of the leveler ball joint link tothe rear mounting holes of the hitch using a 1-8 x4-1/2 hex head cap screw and hex lock nut.NOTEWhen the hitch is in the upper mounting position, theleveler ball joint link is mounted in the lower holes. Whenthe hitch is in the lower position, the link is mounted in thetop mounting holes. See Section 4, “Hitch Adjustment”for proper adjustment.5. Slide one end of the 13” link over the leveler screwassembly. Slide the large end of the 8” link over theother link and secure with a 1” flat washer and 5/16” x2-1/2 spring slotted pin. Repeat this for the other sideof the leveler screw assembly.6. Attach the bottom end of the 8” leveler links to centerframe mount located in the middle of the frame using1" x 7-7/8” leveler pin, washers, and 5/16” x 2-1/2”spring slotted pins.7. Secure the rear of the 13” leveler links in the thirdhole down from the top of the mounting plateslocated on the center lift using 1" x 7-7/8” leveler pin,washers, and 5/16” x 2-1/2” spring slotted pins.