Lang ECCO-AP Service Manual

Also see for ECCO-AP: Installation operation & maintenance Service manual

Contents

Lang ECCO-AP Service Manual Manual pdf 17 page image

16PROGRAMMING ECCO-CProgramming Made EasyThe Lang Purple OvenSingle Tier ProgramsNote: Make sure the oven is ON. There are 3 Steps to Programming the Lang Purple Oven: 1) Use the“Password” to enter the Programming Mode, 2) Programming, and 3) exiting the Programming Mode.Entering the Program Mode:1. The display should read “Enter” before proceeding. If it does not, then hold theRead/Clear button down just until “88888” appears on the display. When you see the8’s, remove your finger and “Enter” will appear on the display.2. Rapidly press the following buttons: “Read/Clear,” 1,6,2,7,3,8.3. The display will now read “PROD.”Programming a Product Button:4. Press the number button you wish to program (program 1-10).5. The display will now read “000°F.” Enter the new program baking temperature or 000to erase a preset program.6. The display will now read “CC0-7.” Enter the new cooking curve (CC) number.7. The display will now read “Fan01.” Press 1 if the program requires the fan ON, orpress 0 if the program requires the fan OFF.8. The display will now read “0:00:00.” Enter the baking/cooking time in minutes andseconds. If the program requires minutes only, enter “00” after entering the minutes toindicate zero seconds.9. Now press the “E” button. This will lock in your just entered program and ask you for anew product button to program. If you have more programs to enter, go back and followsteps 4-9. If you are finished, proceed to step 10 to exit the programming mode.Exiting the Programming Mode:10. To exit the programming mode, simply press the “Read/Clear” button. The display willnow read “Enter.” You are now in the normal operation mode. Press any presetprogram to operate the oven in the baking mode.Note: Once you have exited the programming mode, you can double check your preset programsby quickly pressing the “Read/Clear” button twice, and then quickly press the product number.The program will then come up on the display, reading the program step-by-step.