Lanier LD225 Network Manual

Also see for 8025: Function guide Fax guide Operating instructions Function guide Settings guide

Contents

Lanier LD225 Network Manual Manual pdf 99 page image

Remote Maintenance by telnet934❖ View settingsmsh> ifconfig❖ Configurationmsh> ifconfig “interface_name” “parameter” “ad-dress”• If you did not enter an interfacename, it is automatically set tothe Ethernet interface.• ip1394 can be specified onlywhen the IEEE 1394 interface isinstalled.• wlan can be specified onlywhen the IEEE 802.11b interfaceis installed.❖ Netmask configurationmsh> ifconfig “interface_name” netmask “address”❖ Broadcast address configurationmsh> ifconfig “interface_name” broadcast “address”❖ Changing the Interfacemsh> ifconfig “interface” up• You can specify either the Ether-net interface or IEEE 802.11b in-terface when using the optionalIEEE 802.11b interface unit.You cannot specify the IEEE1394 interface.The following explains how to con-figure an IP address 192.168.15.16on Ethernet interface.msh> ifconfig ether 192.168.15.16The following explains how to con-figure a subnet mask 255.255.255.0on Ethernet interface.msh> ifconfig ether net-mask 255.255.255.0Note❒ To get the above addresses, contactyour network administrator.❒ Use the default configuration if youcannot obtain setting addresses.❒ The IP address, subnet mask andbroadcast address are the same asthat for the ethernet interface andIEEE 802.11b interface.❒ When installing the optional 1394Interface board, set the IP addressand subnet mask so that it does notoverlap with the ethernet interfaceor the IEEE 1394 interface.❒ TCP/IP configuration is the samefor both Ethernet and IEEE 802.11binterface. If interfaces are changed,the new interface inherits the con-figuration.❒ Use "0x" as the initial two letters ofa hexadecimal address.infoUse the "info" command to displayprinter information such as paper tray,output tray, and printer language.❖ Printer information displaymsh> infoReferenceFor details about displayed con-tents, see p.107 “Getting Printer In-formation over the Network”.ippUse the “ipp” command to configureIPP settings.❖ Viewing settingsThe following command displaysthe current IPP settings:Interface name Interface configuredether Ethernet Interfaceip1394 IEEE 1394 Interfacewlan IEEE 802.11b Interface