Lantronix UDS10 User Manual
Also see for Device Server UDS 10: User guideHardware guide
                                                                              | |
Contents
| 
Using Monitor Mode UDS10/UDS100 User Guide44Using Monitor Mode CommandsThe following commands are available in Monitor Mode. Many commands have an IPaddress as an optional parameter (x.x.x.x). If the IP address is given, the command isapplied to another unit with that IP address. If no IP address is given, the command isexecuted locally.Note: All commands must be in capital letters, with blank spaces betweenthe settings.Table 7-1. Monitor Mode CommandsCommand Command Name FunctionSF x.x.x.x Send Firmware Sends firmware to unit with IP address x.x.x.x.VS x.x.x.x Version Queries software header record (16-byte) of unit withIP address x.x.x.x.GC x.x.x.x Get Configuration Gets configuration of unit with IP address x.x.x.x ashex records.SC x.x.x.x Send Configuration Sets configuration of unit with IP address x.x.x.x fromhex records.PI x.x.x.x Ping Pings unit with IP address x.x.x.x to check devicestatus.AT ARP Table Shows the unit’s ARP table entries.TT TCP Connection Table Shows all incoming and outgoing TCP connections.NC Network Connection Shows the unit’s IP configuration.RS Reset Resets the unit’s power.QU Quit Exits diagnostics mode.G0, G1...GE,GF Get configuration from memory page Gets a memory page of configuration information fromthe device.S0, S1... SE,SF Set configuration to memory page Sets a memory page of configuration information onthe device.Entering any of the commands listed above generates one of the following commandresponse codes:Table 7-2. Command Response CodesResponse Meaning0> OK; no error1> No answer from remote device2> Cannot reach remote device or no answer8> Wrong parameter(s)9> Invalid command |
Related manuals for Lantronix Device Server UDS 10
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine