Lantronix WP2002000-01 User Manual

Also see for WiPort-485: User guide

Contents

Lantronix WP2002000-01 User Manual Manual pdf 67 page image

WiPort™ User Guide 6777:: MMoonniittoorr MMooddeeMonitor Mode is a command-line interface used for diagnostic purposes.There are two ways to enter Monitor Mode: locally via the serial port or remotely viathe network.Entering Monitor Mode via the Serial PortTo enter Monitor Mode locally:1. Follow the same steps used for setting the serial configuration parameters (seeSerial Port Access on page 38).2. Instead of typing three x keys, however:a) Type zzz to enter Monitor Mode with network connections.b) Type yyy to enter Monitor Mode without network connections.A 0> prompt indicates that you have successfully entered Monitor Mode.Entering Monitor Mode via the Network PortTo enter Monitor Mode using a Telnet connection:1. Establish a Telnet session to the configuration port (9999). The followingmessage appears:MAC address 00204A0113A3Software version 05.3 (040129) WPTPress Enter to go into Setup Mode2. Type M (upper case).A 0> prompt indicates that you have successfully entered Monitor Mode.Monitor Mode CommandsThe following commands are available in Monitor Mode.Note: All commands must be in capital letters.Table 7-1. Monitor Mode CommandsCommand Command Name FunctionVS Version Queries software header record (16 bytes) of unit.GC Get Configuration Gets configuration of unit as hex records (120bytes).SC Send Configuration Sets configuration of unit from hex records.