Lantronix WiPort User Manual
Also see for WiPort: User guideIntegration guideQuick start guide
                                                                             | |
Contents
| 
Configuration via Serial Mode or Telnet PortWiPort™ User Guide 50Flush ModeThe FlushMode (buffer flushing) parameter controls line handling and network bufferswith connection startup and disconnect.FlushMode ( 0) ? _Select between two different packing algorithms (the current configuration isdisplayed within the parentheses). Available Flush Mode options are:Table 5-12. Flush Mode OptionsFunction 7 6 5 4 3 2 1 0Input Buffer (Serial to Network)Clear with a connection that is initiated from thedevice to the network 1Clear with a connection initiated from the networkto the device 1Clear when the network connection to or from thedevice is disconnected 1Output Buffer (Network to Serial)Clear with a connection that is initiated from thedevice to the network 1Clear with a connection initiated from the networkto the device 1Clear when the network connection to or from thedevice is disconnected 1Alternate Packing Algorithm (Pack Control)Enable 1Pack ControlThe packing algorithm defines how and when packets are sent to the network. Thestandard algorithm is optimized for applications in which the unit is used in a localenvironment. The alternate packing algorithm minimizes the packet count on thenetwork and is especially useful in applications in a routed Wide Area Network(WAN). Adjusting parameters in this mode can economize the network data stream.Pack control settings are enabled in Flush Mode. Set this value to 00 if specificfunctions are not needed.Table 5-13. Pack Control OptionsOption 7 6 5 4 3 2 1 0Packing IntervalInterval: 12ms 0 0Interval: 52ms 0 1Interval: 250ms 1 0 |
Related manuals for Lantronix WiPort
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine