Larson Electronics PDU-ATS Series User Manual

Settings Group 5 ControllerEngine Exerciser SettingsThe controller (CP) engine exerciser setting can be displayed and changed from thekeypad. Some settings may require a password (if the controller is set up for one).¡From any of the Status displays, press the enter/save settings key to move to theSettings level of menus.© Press the right arrow key to move to Setting Time Delays menu.¢ Press the right arrow key again to move to Settings Features menu.£ Press the right arrow key again to move to Settings General menu.¤ Press the right arrow key again to move to Settings Engine Exerciser.¥ Now press the enter/save settings key to move to the first Engine Exercisermenu.¦ You can press the right arrow key to see the other Engine Exerciser menus(as shown below). An overview explanation of each setting is listed below.8 Engine Exerciser Settings Menus(last menu loops back to first)Present Date/Time see page 6This display allows the user to change the controller date and time.US DST — US Daylight Saving Time. APR – OCT, MAR – NOV, or OFF.MAR – NOV begins in 2007.P(1—7) Engine Exerciser(s) see page 6These displays (P1 through P7) allow the user to set the controller’s sevenindependent engine exerciser routines. Each routine functions in the samemanner. Six parameters need to be configured for each routine (P1, P2,P3, P4, P5, P6, P7 — not all have to be used).Enable — YES enables the routine; NO turns it off.wLoad — YES transfers load to Emergency; NO = no transfer.Start — when the routine will start the generator– time (hour, minute)– week (all, alternate, 1st, 2nd, 3rd, 4th, or 5th week)– day of the week (mon, tue, wed, thu, fri, sat, sun)Run Time — duration (length of time) that the generator will run.Larson Electronics, LLC Phone: (877) 348-9680 Fax: (903) 498-3364 www.larsonelectronics.com 16 of 33