Larson Electronics PDU-ATS Series User Manual

Group 5 Controller SettingsService — Factory Selectable FeaturesThe controller service factory selectable features can be displayed from themembrane controls. These factory settings should not be changed by thecustomer (they cannot be changed without entering the factory password).¡ From the ATS Status display (NORMAL OK), press the enter/save settingsbutton to move down to the Settings level of menus.©¢£¤¥¦§ Press the right arrow key 7 times to move to Service menu.¨ Now press the enter/save settings button to move down to the first Servicefactory selectable feature.You can press the right arrow key to see the other Service menus (as shown below).An overview explanation of each setting is listed below.8 Service Menus (last menu loops back to first)ATS InformationThis display shows the transfer switch ampere size, whether the switch is abypass switch or a non–bypass switch, and any name or description inform–ation that has been assigned to it through the serial communications port.Test or Manual Mode InputThis display shows the setting of the Feature 5/6Z input. This input can be used foreither Feature 5 or 6Z. Yes means active; no means not used.Test Operation — Feature 5Manual Operation — Feature 6ZThis Feature is not available for automatic operation.Retransfer Mode InputThis display shows the settings for Features 6B/6C inputs. This input can be usedfor either Feature 6B or 6C. Yes means active; no means not used.TD Bypass — Feature 6BManual Re Xfer — Feature 6CThese Features are typically set to Yes with the inhibit Feature overridden withexternal factory wiring. These Features are not available for customer use.Xfer to Normal Inhibit and Emergency (not shown)This display shows whether the Feature 34A input is enabled (yes) or disabled (no).Likewise, the next display Xfer to Emerg shows whether the Feature 34B input isenabled (yes) or disabled (no).Factory Calibration (not shown)This display is for factory calibration only and should be used by factory personnelonly.OtherThese displays show various parameters that should be accessed by factorypersonnel only.Larson Electronics, LLC Phone: (877) 348-9680 Fax: (903) 498-3364 www.larsonelectronics.com 19 of 33