LaserLiner ClimaData Box Manual

Contents

ClimaData Box175.2 LED cycle settingActive recording is signalled by the LED (3) and “REC” on the display.The LED signal can be set to appear every 10, 20 or 30 seconds.Or the LED signal can be switched off.5.1 Sampling rateThe sampling rate defines how often measurements are recorded. Settingoptions: 1 … 60 seconds, 1 … 60 minutes and 1 … 24 hours. The maximummeasurement duration is calculated under “Recording time”. The measurementmemory is full at the end of this time. See also section 5.6 “Continuous /non-continuous recording”.5 Setup menuMeasurement-specific settings on the connected device can be defined inthe Setup menu.Sampling rate Alarm setupLED cycle settingSampling rateRecordingtime 1 day 21 hrs. 25 min. 0 sec.ConnectedSeconds10sManual Automatic20s 30s NoneHoursTime lagon startCurrent timeTemp alarm lowRH alarm lowDP alarm lowTemp alarm highRH alarm highDP alarm highUnitCelsiusLED flashes when alarm signals low / highAlarm when recording is not activeContinuousrecording Non-continuousrecordingReset Configure CancelReset to factorysettingsClose Setup menuwithout savingSavesettingsNew configuration automatically deletes all existing data.!EN