LaserLiner CoatingTest-Master Instruction Manual

Contents

261010.111ZeroμmDIR FeNO AVG 100101.01The zero point setting should be checked and, if necessary, corrected beforeeach measurement.Zero calibrationChecking/Calibrating the zero point1 Turn the device off/on2 Set the measuring mode:Menu > Options > Measure mode > Single modeExit the menu: press key 1 twice3 Perform measurement (see item 12):measurement on uncoated material(original material or reference material)Value within tolerance (see technical data):check complete; no calibration necessaryValue outside tolerance (see technical data):Calibration required: press and hold the ZERO key (3);repeat steps 1-3 to checkOne-point calibration calibrates a coating thickness as closeto the expected measured value as possible.One-point and two-point calibration3VN ONHMSB@KHAQ@SHNMCDÖMDR@RDBNMCBN@SHMFSGHBJMDRRin order to increase the measuring accuracy. The expectedmeasured value should be as close as possible to the mid-point between the calibration points (cal 1 and cal 2).,TKSHOKDÖKLRL@XADBNLAHMDCENQFQD@SDQBN@SHMFthicknesses.Example: expected coating thickness: 75 μmCalibration point 1:,D@RTQDLDMSVHSGQDEDQDMBDÖKL50 μm ± 1%Calibration point 2:,D@RTQDLDMSVHSGQDEDQDMBDÖKL101 μm ± 1%EN