Lathem DDC2 Series Installation And User Manual

Also see for DDC2 Series: Installation & user guide

Contents

Lathem DDC2 Series Installation And User Manual Manual pdf 25 page image

Page 19 Digital Display Wall Clock GuideDDC4 (Double Mount - Ceiling)Note: Make sure you have at least 16" of side clearance on one side in order to remove the front panelassembly.» Remove the two phillips head screws from the left and the right end caps of the two DDC4 clocksand remove. Slide the front panel assemblies out of the cases and set aside.» Place the two DDC4 clocks back to back and secure by inserting a #10 screw through the two keyholes and the two lower mounting holes using lock washers and nuts supplied with the mountingkit. Note: At this point, if the DDC4 clocks will be mounted too near a wall on one side to securethe end caps, install the "wall side" end caps now.» Remove the center vent cap from the top of each DDC4 clock.» Line the two posts from the mounting plate up with the vent holes of the DDC4 clocks. Insert thechase nipples through the vent holes and secure to the mounting plate with a 15/16" wrench.» Slide the front panel assemblies in partially. Secure the required wiring and install the battery ifused.» Slide the front panel assemblies in fully. Install the end caps and secure each with its two screws.Note: When mounting DDC4 clocks, thelong side of the mounting plate must beparallel to the long side of the clockschase nipplechase nipple#10 screws#10 lock washers#10 hex nutsmounting plateDDC4 casesFigure 7