Lathem PC600 User Manual
Also see for PC600 Series: Quick start guideUser guide
                                                                                                | |
Contents
| 
P A Y C L O C K & P C 6 0 0 U S E R ’ S G U I D E7Install the PC600Step 1: Select a site to install your PC600 terminal that will beconvenient to employees clocking in and out. When deciding wherethe terminal will be installed, keep in mind that an 115vAC poweroutlet should be within 6 feet of the mounting location as well as aconnection to the network (LAN).Note: It is recommended to install and mount the PC600 terminalbefore installing the PayClock software. With the PC600 terminalpowered up and connected to the network (LAN), the software willsearch for it on the network and automatically configure the terminal.Step 2: After selecting the appropriate installation site, use maskingtape to hold the included Mounting Template onto the wall. Drillholes using the template as a guide. Note: the bottom of the terminalshould be about 45 inches from the floor.Remove the Template from the wall and install the includedmounting screws. Install the three larger screws, leavingapproximately 3/16 inch of the screws exposed. Do not tighten allthe way. Retain the smaller screw for later.Note: For sheetrock walls, drill a 3/16” diameter hole through eachof the four screw locations; each approximately 1-1/2” deep. Installthe plastic “anchors” included in the mounting screw packet. |
Related manuals for Lathem PC600 Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine