Lattice Semiconductor iCE40 UltraPlus Series User Manual

Contents

Lattice Semiconductor iCE40 UltraPlus Series User Manual Manual pdf 6 page image

MDP Based Key Phrase Detection DemonstrationUser Guide© 2018 Lattice Semiconductor Corp. All Lattice trademarks, registered trademarks, patents, and disclaimers are as listed at www.latticesemi.com/legal. All other brand or product names aretrademarks or registered trademarks of their respective holders. The specifications and information herein are subject to change without notice.6 FPGA-UG-02048-1.0Table 3.1 provides detailed information on the MDP switch and jumper configuration.Table 3.1. MDP Board Configuration DetailsItems Configuration DescriptionJ17, J26, J27 Shunt pin 9 - 10 Disable iCE40UP5K A/C/D devicesJ25 Shunt pin 1 - 2 Enable iCE40UP5K_B deviceJ25 Shunt pin 3 - 4 Provide Onboard Mic connection to FPGAJ28 Shunt pin 1 - 2 Board control, for programming SPI FlashJ19 Shunt pin 1 - 3, 2 - 4 (vertical) Enable programming SPI FlashJ23 Shunt pin 2 - 3 Use Xtal U14 as clock sourceSW2 Set to ON Power Switch, slide down for power-onSW5 (2,1) OFF, ON To select iCE40UP5k_B(U2) as target device*Important: If using Rev C MDP board, check the MDP Revision Guide to ensure that your MDP board has the correctresistor series. The MDP Revision Guide is provided in the Documentation folder of MDP Based Key Phrase DetectionDemonstration Bitstream.