Lumel RE72 User Manual

Also see for re72 series: User manual Quick start manual User Manual & Quick Start User Manual & Quick Start Quick start

Lumel RE72 User Manual Manual pdf 10 page image

RE72-09B User’s Manual 106.1. Programming Controller ParametersThe pressure and holding down the @ push-button during ca 2 sec. causes the entry in theprogramming matrix. The programming matrix can be protected by an access code. In case whengiving a wrong value of the code, it is only possible to see settings through – without the possibility ofchanges.The fig 14. presents the transition matrix in the programming mode. The transition between levels iscarrying out by means of ? and > push-buttons and the level selection by means of the @push-button.After selecting the level, the transition between parameters is carried out by means of ? and >push-buttons. In order to change the parameter setting, one must proceed acc. to the section 6.3. Inorder to exit from the selected level, one must transit between parameters until the symbol [. . .]appears and press the @ push-button.In order to exit from the programming matrix to the normal working mode, one must transit betweenlevels until the symbol [. . .] appears and press the @ push-button.Some controller parameters can be invisible – it depends on the current configuration.The table 1 includes the description of parameters. The return to the normal working mode followsautomatically after 30 seconds since the last push-button pressure.Automatización IndustrialTelf.: 423-5567 / 711-9345 - RPM.: #981156320 / *975084 / #999976999 E-mail.: ventas.1@csrimport.com / www.csrimport.comAutomatización Industrial