MAAX 300 Series Owner's Manual
                                                                       | |
Contents
| 
24 Owner’s ManualEnglishhour increments of 1- 8. For example, a 2hour cycle will complete once every 12 hoursfor a total of 4 hours per day. The amount oftime needed to filter your spa will depend onusage and ambient conditions.You will need to program your filter cyclesbased upon your personal use.To change the duration of the filter cyclestouch the ‘TEMP’ pad and then touch the‘JETS’ pad. Touch the ‘TEMP’ pad to adjustthe cycle duration to the desired setting. Aftereach press, the duration of the cycle will bedisplayed in the LCD window as follows:F1 1 Hours for each cycle, 2 hours per dayF2 2 Hours for each cycle, 4 hours per dayF3 3 Hours for each cycle, 6 hours per dayF4 4 hours for each cycle, 8 hours per dayF5 5 hours for each cycle, 10 hours per dayF6 6 Hours for each cycle, 12 hours per dayF7 7 Hours for each cycle, 14 hours per dayF8 8 Hours for each cycle, 16 hours per dayTo exit the filter-set procedure, touch ‘JETS’.The LCD window will display the current watertemperature.If a change is made to the duration while thespa is in a filtration cycle, it will take effectimmediately. If the change is made outside afiltration cycle, it will take effect at the start ofthe next scheduled cycle.NOTE: When power to the spa is denied(disconnect, power outage), the controlsmay revert to the default factory settings.Any adjustments to set temperatureor filter cycle duration may need to bereprogrammed.LightTouch the ‘LIGHT’ pad to turn all lights on andoff. The lights will automatically turn off after 4hours of operation.When in Standard mode, the letters ‘ST’are displayed beiefly, followed by the watertemperature. When in Economy mode, theletters ‘EC’ are displayed alternately with thewater temperature.When in Sleep mode, the letters ‘SL’ aredisplayed alternately with the water temperature.Setting the Time and Filtration CyclesYou can decide when your filter cycles startand how long they run.Preset Filter Cycles. The spa control systemis designed with two filter cycles. The firstfilter cycle turns on 6 minutes after power issupplied to the spa. The second filter cycleturns on 12 hours later. Filter cycles are pre-setfor a two hour duration.Note: To properly clean and maintain spa, atotal filter time of at least two hours per dayis recommended. If an ozonator is installed,4 hours is recommended.Changing Filter Cycle Start TimeThe start/stop times of the filter cyclecorrespond to 6 minutes after the spa settime is established. Set time is based on thetime of day that the spa is powered up. Settime may only be changed by disconnectingpower from the spa and re-connecting it atthe desired start time. For example, if youwant the filter cycle to begin at 9:00 PM,turnoff the spa breaker and turn it back on at 8:54PM (remember the 6 minute wait period). Thecycle will begin at 9:00 PM and will repeatbeginning at 9:00 AM. Each cycle will run forthe prescribednumber of hours.Changing Filter Cycle DurationThe duration of a filter cycle can be set in one |
Related manuals for MAAX 101
This manual is suitable for:
101102103300 Series3113703713803814100420044004514600461470471472480481482501 Series504 Series5100520053005400560058170007500780781800081185009000AmourCabaretChateauCirqueDuetElegantEnvieESESRESXFontaineForteGrandImageIntrigueJoliM50M61M71MonarqueMXBP20MXBP501MystiqueNuagePrestigeRendezvousTrioVoeux
manualsdatabase
Your AI-powered manual search engine