MAAX 300 Series Owner's Manual
                                                                       | |
Contents
| 
30 Owner’s ManualEnglishUser’s PadsUser’s Pads are the buttons located on thetopside control panel and are used to programvarious spa functions (i.e., turn on spa light, settemperature, etc.). The following table definesthe pads:Pad Use• Increase temperature• Change time settings• Decrease temperature• Change time settings• Switch heating modes• Turn internal spa light onor off• Optional. Turns blowersystem on or off. Same asTurbo• Activate primary filtrationpump• Activate therapy pumpTemperature ControlsThe maximum set temperature is 104°F (40°C)and the minimum set temperature is 80°F(26°C). The current water temperature or, if thepump has not been running, two dashes, willshow on the display. If dashes are displayed,you must first start the pump by pressing the‘JETS 1’ pad. Wait until the water temperatureis displayed (approximately 2 minutes).The set temperature of your spa may easily beincreased or decreased at any time using the‘UP’ or ‘DOWN’ pads. When either of thesepads is touched, the set temperature will bedisplayed in the LCD window. Each successivetouch will change the set temperature 1°F(0.5°C) in the chosen direction. After 3 secondsthe LCD will automatically display the watertemperature or dash lines.If the spa is set in Standard mode or in afiltration cycle, adjusting the set temperaturemay result in activating the heater. Whenthe heater is operating, the heat icon will bedisplayed in the LCD.Note: 230-Volt spas that are wired with thelow Amp option will not heat when Pump1 is on in high speed, or when Pump 2 is inoperation.JETS 1Touch the ‘JETS 1’ pad to activate the primaryfiltration pump. The sequence of the jet action is:1 touch = Low jets2 touches = High jets3 touches = OffJETS 2Touch the ‘JETS 2’ pad to activate the therapypump. The sequence of jet action is:1 touch = High jets2 touches = OffThe low speed operation of Pump 1 is timedto automatically turn off after 2 hours ofoperation. The high speed operation of Pump 1and the high speed operation of Pump 2,are timed to automatically turn off after 15minutes of operation.1 11111rlay Template (VL701S)o create overlay graphics only. Do not use this template to create a die cutting tool.1 11111plate (VL701S)nly. Do not use this template to create a die cutting tool.1 11111Overlay Template (VL701S)Use this to create overlay graphics only. Do not use this template to create a die cutting tool.1 11111Overlay Template (VL701S)Use this to create overlay graphics only. Do not use this template to create a die cutting tool.1 11111 |
Related manuals for MAAX 101
This manual is suitable for:
101102103300 Series3113703713803814100420044004514600461470471472480481482501 Series504 Series5100520053005400560058170007500780781800081185009000AmourCabaretChateauCirqueDuetElegantEnvieESESRESXFontaineForteGrandImageIntrigueJoliM50M61M71MonarqueMXBP20MXBP501MystiqueNuagePrestigeRendezvousTrioVoeux
manualsdatabase
Your AI-powered manual search engine