MABIS 04-595-001 Instruction Manual

Contents

MABIS 04-595-001 Instruction Manual Manual pdf 7 page image

Before applying your blood pressure cuff, be sure you have selected the appropriate cuff:Small Adult Cuff fits arm circumference 8-5/8” - 11-3/4” (22-30 cm)Adult Cuff fits arm circumference 11-3/4” - 16-1/2” (30-42 cm)Large Adult Cuff fits arm circumference 16-1/2” - 18-7/8” (42-48 cm)NOTE: If for any reason you are unable to or should not use your left arm, please modifythe following instructions and apply the cuff to your right arm.Your physician can tell you which arm is best for you to use.1. Remove any constrictive clothing or jewelry that mayinterfere with the cuff placement.2. Be seated with your feet flat on the floor.3. Position the cuff on a solid surface with the tubing facingUP and AWAY from you, Fig. 1. The metal bar on the cuffshould be to the left of the tubing.4. Widen or open the cuff by pulling or rolling thebottom of the cuff towards the right, Fig. 2.This should open the cuff, creating a cylinder.Do not extend the cuff beyond the metal bar.5. Insert your arm into the cuff (cylinder).Position the ( ) mark over the main artery(on the inside of your arm), Fig. 3.6. The bottom edge of the cuff should bepositioned approximately one inch ABOVEthe elbow joint, Fig. 4.7. Reaching underneath your left arm with yourright hand, pull the end of the cuff towardsyour body to tighten the cuff, Fig. 5. Wrap andsecure the cuff making sure that the ( ) markremains as shown, Fig. 3.8. The cuff should fit comfortably, yet snugly around your arm.You should be able to insert two fingers between your armand the cuff.NOTE: The cuff size is suitable for use when the vertical “Index” mark is within thehorizontal “OK” range. A different sized cuff is needed if the “Index” mark is outside of the“OK” range. – 13 –To set the desired voice language:1. When the unit is off, you can select the desired voice language by pressing andholding the MEMORY button.2. Now the screen will cycle through L0, L1 and L2 as shown in Fig. 1.L0 - voice function is offL1 - voice is in EnglishL2 - voice is in SpanishThe monitor will say the corresponding language with the displayed language code.3. Once the desired language has been selected, release the MEMORY button.4. After the desired language has been selected, you can adjust the volume by pressingand holding down the MEMORY button until the bars on the side of the screen beginto increase Fig. 2.5. Continue to hold the MEMORY button down until the volume reaches the desiredlevel, then release the MEMORY button to set.6. The unit will automatically turn off after the desired volume level has been set.Fig. 1 Fig. 2Voice Language Setting– 12 –Applying Your Blood Pressure CuffFig. 1Fig. 41”Fig. 5Fig. 3Fig. 2

/ 10

Related manuals for MABIS 04-595-001