MYTRIX Dreamweaver User Manual
                                                        | |
Contents
| 
Mytrix Technology - http://www.mytrixtech.com2014 Mytrix TechnologyAll rights reserved Third Version51unplug the cooling fan of machine.3、Q：Unable to load the filamentA：the reasons could be as follows1. The temperature has not reached the best melting point of the filament. Adjust thetemperature, usually to increase.2. The filament tie knots on the feeding tray, so the filament is stuck, cut it and thenadjust the filament, the print could be resumed.3. The distance between the print platform and nozzle is too close, it will stuck thenozzle. Low down the platform by adjusting the horizontal adjustment nuts.4. The filament diameter is too large, cut it and change to a better one.5. Nozzle is damaged, contact the customer serve if it is damaged for all kinds ofreasons.4、Q：Displace during printingA：possible causes1. It could be winded or blocked, check whether the sliding cross-shaped base iswinded by filaments or blocked by a certain objects, eliminate them.2. Too much dust on the Axis leads to the increase of friction. Use a tissue or alcoholpad to clean the dust.Chapter 11 NoticePlease read all of the following safety and operating instructions before use, to voidburn, electric shock, fire and other accident.1. Please use this printer under right voltage and abide by local laws.2. Do not throw, disassemble, squeeze, burn your 3D printer, do not load unsupportedfilaments. |
Related manuals for MYTRIX Dreamweaver
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine