2345678PARTS DIAGRAM936) Feed the hose through the hose guide, fit the hose stopper,then unlatch the drum. The hose stopper should now sitsnuggly against the hose guide.4) Replace all the washers and nuts around the outside of thedrum assembly and securley tighten.5) Turn the drum anti-clockwise until you feel the spring startto tension, then turn the drum three complete turns andlatch the drum.LATCH REPLACEMENT1) Working from the swivel side of the reel, remove the 4 boltsholding the swivel body to the axle, then remove the swivelbody.4) Remove the 4 large bolts holding the support arm to themounting bracket located below the swivel body.6) Inspect the latch assembly, and replace any worn ordamaged parts.7) Assembly is a reversal of the disassembly proceedure.1 72) Remove the circlip holding the axle bearing in place.3) Remove the nut and bolt holding the roller guide to thesupport arm.5) Slide the support arm off the axle.6*ITEM NO DESCRIPTION REEL MODEL NUMBERMATP1220 MATP1230 MATP1920 MDTP1920 MDTP2520 MDTP3820 MGTP0615 MGTP0915 MOTP1215 MOTP1220 MOTP1920 WPTP10501 ROLLER GUIDE SET * * * * * * * * * * * *2 SWIVEL ASSEMBLY RW39S RW 49S RW59S RHA39S RHA49S ROA69S RHA09S RHA19SG RHA35S RHA39S RHA59S RW 39MF3 SWIVEL SEAL SET (not shown) RW40S RW 50S RW60S RHA40S RHA50S ROA70S RHA10S RHA20SG RHA36S RHA40S RHA60S RW 40MF4 SPRING DRUM ASSEMBLY * * * * * * * * * * * *5 LATCH SET * * * * * * * * * * * *6 SCREW AND NUT SET * * * * * * * * * * * *7 NUT AND BOLT * * * * * * * * * * * *8 BOLT * * * * * * * * * * * *9 BOLT * * * * * * * * * * * *10 HOSE ASSEMBLY (not shown) HPW41S HPW51S HPW61S HPA41S HPA51S HPO71S HPA11S HPA21SG HPA37S HPA41S HPA61S HPW42MF11 HOSE STOPPER (not shown) RW42S RW 52S RW62S RHA42S RHA52S N/A RHA12S HPA22SG RHA38S RHA42S RHA62S N/A