4ANTENNA TVA combination antenna receives normal broadcast channels (VHF 2–13 and UHF 14–69). Your connection is easy because there is onlyone 75 Ω (ohm) antenna jack on the side of your TV, and that’s where the antenna goes.If your antenna has a round cable (75 ohm) on the end, thenyou’re ready to connect it to the LCD TV. If your antennahas flat, twin-lead wire (300 ohm), you first need to at-tach the antenna wires to the screws on a 300- to 75-ohmadapter(not supplied).Connect the antenna (or adapter) to one end of thesupplied L-Adapter as shown, and connect the other end ofthe L-Adapter to the TV jack on the side of the LCD TV.Plug the DC adapter into the DC IN 16V jack on the LCDTV. Plug the power cable into an outlet and switch TV set on.Run the AUTO PROGRAM function to set up the TV for thebroadcast or cable channels available in your area. If you donot run the auto program function to set up the channels ,your television may not operate properly.121Antennawith 75 ΩcableRear Jack panel ofTelevisionOutdoor or Indoor Antenna(Combination VHF/UHF)OR2Twin-leadwire to300-75ΩadapterDC AdapterPowerCable3Your Cable TV input into your home may be a single (75 ohm) cable or use a cable box decoder. In either case the connection is verysimple. Follow the steps below to connect your cable signal to your new television.Direct cable connections:Connect the Cable TV signal to one end of the suppliedL-Adapter as shown, and connect the other end of theadapter to the TV jack on the LCD TV.Plug the DC adapter into the DC IN 16V jack on the LCDTV. Plug the power cable into an outlet and switch TV set on.Run the AUTO PROGRAM function to set up the TV for thebroadcast or cable channels available in your area. If you donot run the auto program function to set up the channels ,your television may not operate properly.132B ASIC CABLE TV C ONNECTION1The Cable TV signal fromCable Company(75 coaxial cable)Rear Jack panel ofTelevisionΩDCL AdapterAdapterPowerCable243• Remember, an antenna or cable TV signal must first be connected toyour LCD TV.• Please make sure that you have selected the TV mode with source keyon your remote control, before installing TV channels.HELPFUL HINT• Remember, an antenna or cable TV signal must first be connected toyour LCD TV.• Please make sure that you have selected the TV mode with source keyon your remote control, before installing TV channels.HELPFUL HINT