EN-10ENGLISHFRANÇAISEESPAÑOLConnect the AC power cord4.4WARNINGB :Verify that your voltage corresponds withthe voltage printed at the back of the TV.Do not insert the AC power cord if thevoltage is different.To connect the AC power cordCableReceiver BoxLocate the power connector at the back of the1.TV. The location of the power connector variesaccording to TV model.Insert the AC power cord fully into the TV2.power connector.Connect the AC power cord plug to the power3.outlet. Ensuring that the cord is tightly securedat both ends.4.5 Manage cablesRoute your AC power cord, antenna cable and allother device cables through the cable holder at theback of the TV. The holder helps keep your cablestidy and easily manageable.75 ΩSwitch on the TV4.6Before you switch on the TV, check that the mainscord is properly connected. Press POWERbutton at the front side of the TV, or press powerthe remote control. The TV normally takes 10-15seconds to start up and the following screen appearsthe first time you turn on the TV.Thank you for your purchase TV.Please proceed with the following steps to set-up your TV. For the BESTpossible picture performance, contact your local Cable / Satellite signalprovider for High Definition signal options available in your area.NextThank you for your purchase TV.Please proceed with the following steps to set-up your TV. For the BESTpossible picture performance, contact your local Cable / Satellite signalprovider for High Definition signal options available in your area.NextPress the GREEN Next button on your remote to proceed.Press the GREEN Next button on your remote to proceed.Follow the on-screen instructions to select yourlanguage and complete your TV setup. Installationtakes approximately 10 minutes.Note:D If you connect your TV to a cable receiverbox or satellite set-top box, you do not needto install channels. Press the red button on theremote control to exit the channel installationstage of the setup.