6 ENINTRODUCTION55 Attaching5the5StandYou must attach the stand to the unit to have it as a table top unit. Be sure the front and rear of the stand match the proper direction.Note:• When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall,resulting in injuries as well as damage to the unit.• Make sure to use a table which can support the weight of this unit and is larger than this unit.• Make sure the table is in a stable location.Note:• For 32MD350B, nonremovable AC power cord is already fixed on the unit.55 Supplied5Accessories1 Spread a thick and soft cloth over atable as shown below.Place the main unit face down onto it.Make sure not to damage the screen.At least 2 people are required at thisstep.2 Align the 2 stand hooks with the twohooks under the bottom of the mainunit (shown by arrow ), then slidethe stand in the direction as shownby arrow until it stops and themounting holes are aligned.For 32MD350BMake sure not to put the AC powercord between the stand and the unit.3 Drive Phillips pan screws inthreaded holes at the bottom of thestand until they are tight.To remove the stand from this unitUnscrew the Phillips pan screws on step 3.After the screws are removed pull the stand up toward the rear of the unit. Be careful not to drop the stand when you remove it.AAAAAAAA• If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll freecustomer support line found on the cover of this manual.front sidefront sidescrew kit for attaching the standFor 37MD350B 3 screws (1ESA20208)For 32MD350B 4 screws (1ESA19508)user manual(1EMN25919A)quick start guideFor 37MD350B(1EMN25960)For 32MD350B(1EMN25920)remote control(NF801UD)batteries(AAA, 1.5V x 2)registration card(1EMN24699)For 37MD350B onlyAC power cord(WAV0162LW001) or(WAV0162LTE03) or(WAV152ZHN001)