Magnavox 32MD357B - 32" LCD TV User Manual

Also see for 32MD357B - Hook Up Guide: User manual Specifications User manual Specifications Read me

6752IMDH1IMDH CABLE OR ANTENNA75Cable box/OUTOUTPUT(TO TV)INCABLE32ANTENNAWatching cable TV programs that don’trequire the use of a cable box.Since you’ve connected the cable TV signaldirectly to the TV’s tuner, you can also watchunscrambled programs by simply tuning tothe desired channel; however, you must first useAuto program to store available channels in theTV’s memory. (p. 13)Note: This connection will supply stereo sound to theTV if the station you are viewing broadcasts stereosound.Cable boxOUTIN75CABLE OR ANTENNASPLITTER32CABLE14 AV3:L+R+VIDEOANTENNAVIDEOINRLS-VIDEOPC INVGAHDMI2 HDMI1 Y Pb Pr RLY Pb Pr RLAV1AV2AV3- Cable TVConnect the cable TV signal to the CABLE/ANTENNA 75 jack at the bottom of the TV.See page 13 for details on using Autoprogram to storechannels in the TV’s memory.Note: This connection will supply stereo sound to the TV ifthe station you are viewing broadcasts stereo sound.- Cable box with RF IN/OUT• Connect the incoming cable TV signal to the cable INjack on the back of the cable box.• Connect a coaxial cable (not supplied) from the TO TVjack on the back of the cable box to the CABLE/ANTENNA 75 jack at the bottom of the TV.Note: Your cable box may have a different label for the TOTV jack. Commonly used labels include OUTPUT or OUT.• Set the OUTPUT CH switch on the cable box to CH3 or 4 (whichever is correct for your cable box), Next,tune the TV to the corresponding channel. Oncetuned, change channels using the cable box, not the TV.Note: This connection will not supply stereo sound to the TV. Thereason is that the RF output on a cable box - labeled TO TV, OUTor OUTPUT for example - will not send a stereo signal to the tuner(VHF/UHF) input on a TV.- Cable box with A/V outputs• Connect the incoming cable TV signal to a signalsplitter (not supplied). The signal splitter enables you to avoidhaving to use the TO TV jack on the back of the cable box.This jack will not supply stereo sound to the TV.Note: Your cable box may have a different label for the TOTV jack. Commonly used labels include OUTPUT or OUT.• Connect a coaxial cable (not supplied) to a connector onthe signal splitter and to the CABLE/ANTENNA 75jack on the TV.• Connect another coaxial cable (not supplied) to aconnector on the signal splitter and to the cable IN jackon the back of the cable box.• Connect A/V cables (not supplied) to the VIDEO IN andAUDIO L and R outputs on the back of the cable boxand to the AV3 video (labeled VIDEO IN) and AUDIO(labeled L and R) jacks on the back of the TV.• To view programs from your cable box, first press theSOURCE button on the remote control.• Press the cursor down or up buttons until the AV3 signalsource is selected.• Press the OK button to confirm your selection. The AV3input source becomes current for the viewing of cable TVprograms through your cable box.Note: If your cable box audio/video outputs do not supplyvideo and stereo audio to the TV, you will need to make theconnection shown above in “Cable box with RF IN/OUT.