Magnavox 32MD357B - 32" LCD TV User Manual

Also see for 32MD357B - Hook Up Guide: User manual Specifications User manual Specifications Read me

14In the antenna mode, select a channel from the displayed list ofTV channels. Select the “Start” by pressing red button on theremote control; TV set will detect the signal.The signal strength is continuously displayed and updated as yourotate the antenna.When strength is enough to identify, user can store thechannel in the channel list by pressing green button on theremote control.Note: Digital Channel selection delayDue to the tuning complexity of subchanneldigital programming, the time to select and viewa digital channel may take slightly longer thanwhat the viewer is normally accustomed to (ascompared to analog channel programs).Digital channel broadcasts contain program andsystem data information that must be processedbefore the channel selection can be displayed.Channel tuningAvailable channels:- Cable (analog NTSC or digital QAM)- Terrestrial (analog NTSC or digital ATSC)If a tuned channel is not yet in the master channel map, the TVwill attempt to tune to the channel and it will be added to themap.If the channel is not acquired, a message will appear reportingthat the channel is not available. When you tune an audio-onlydigital subchannel, a display appears with the message Audio only.Note: Subchannel selectionsThe new standards employed with digital broadcasting make it possibleto receive multiple program channels under a single major channelnumber which can be selected by pressing the digit remote controldirect-access channel number entry.Important:After the installation of the TV channels is completed, alwaysmake a selection in the Installation menu between Antenna orCable whether you want to watch Antenna TV channels or CableTV channels.If you make use of a signal splitter do not forget to put the switchin the corresponding position.Weak channel installationCurrent software infoThis menu will appear with your TV software information.Press the MENU button on the remote control.Use the cursor down to select Installation in the Settings menu.Using the cursor up/down to choose Current software infothe TV software information is displayed.Installation Current software infoInfoSettingsAutoprogramSourceClockWeak channel installationLanguageReset AV settingsFXXXXXXXXX CPT DemoCurrent software infoInstallation Weak channel installationInfoSettingsAutoprogramSourceClockCurrent software infoLanguageReset AV settings34567892Weak channel installation12Antenna reception for broadcast channels may vary. If you arehaving difficulties acquiring weaker signals, we suggest you use:Weak Signal Installation feature.Here’s how:123