Magnavox 37MF301B Owner's Manual

Also see for 37MF301B: Quick start guide

11 INTRODUCTION PREPARATION WATCHING TV USING FUNCTIONS USEFUL TIPSCONNECTING DEVICES INFORMATIONEnglishThese operations are accessible by remote control.Some may also be accessible by controls on the main unit.Initial SetupThis section will guide you through the unit’s initial settingwhich includes selecting a language for your on-screen menuand autoprogram, which automatically scans and memorizesviewable channels.Before you begin:Make sure the unit is connected to antenna or cable.1 After making all the necessary connections,press to turn on the unit.• It may take a few moments to turn on the unit for thefirst time.• [Initial Setup] menu appears automatically after theunit is turned on.2 Use ▲/▼ to select the on-screen language from thechoices (English / Español / Français) on the right side of theTV screen, then press OK.3 Use ▲/▼ to select [Antenna] for TV channels or [Cable]for CATV channels, then press OK.Initial SetupMake sure the antenna is connected to ''ANT. IN'' jack.Select your signal source.AntennaCableSkipAntennaCable OrANT.INSelect OK OK BACKBack MENUSkip• [Autoprogram] will begin.Initial SetupPlease wait while the system is scanning for channels.Auto programming may take more than 20 minutes tocomplete.0%Digital channels 0 chAnalog channels 0 chMENUSkip4 Use ◄/► to select the desired location setting, then pressOK.Initial SetupSelect “Retail” or “Home” for your location.Retail HomeSelect OK OK• Select [Retail] store, the unit will be set up withpredefined setting for retail displays.• Select [Home], the unit is set to maximize the energyefficiency for home setting and it can be adjustedthrough a choice of picture and sound quality accordingto your preference. Use this setting to remove theE-Sticker if visible from the display. ➠ p.23• When the initial setup is completed, the lowestmemorized channel with the confirmation message ofthe location setting will be displayed on the TV screen.• You must set [Home] in step 4. Otherwise, [Picture]and [Sound] settings you adjusted will not bememorized after the unit goes into standby mode.Note• If you are not receiving a signal from your cable service, contactthe Cable provider.• If you press or MENU during autoprogram, this setup of TVchannels will be canceled.• The initial autoprogram function can be executed for either[Antenna] or [Cable] only once. When you change theconnection (Antenna / Cable), set [Autoprogram] again. ➠ p.17• If there is no signal input from the antenna terminal and nooperation for several seconds after you turn on the unit, helpfulhints appears. Follow the instructions listed on the TV screen.Initial SetupNo channel is registered.Try Autoprogram again?Verify that you have a cable connected to the “ANT. IN” jackon the back of the TV, the channel installation processsearches this connection. If you are using a cable or satellitebox, please confirm the input which you have connected to thebox and press “SOURCE” key on the remote control to selectthe appropriate source input.RetryLaterSelect OK OK MENUSkipAfter an initial setup is completed...• If you want to scan the channels automatically again.[Autoprogram] ➠ p.17• You can add the desired cable and analog channelsunmemorized by autoprogram.[Add Channels] ➠ p.18• If you want to change to another language.[Language] ➠ p.23• If you want to change the location setting.[Location] ➠ p.23