Magnavox 40MV336X Owner's Manual

Also see for 40MV336X: Owner's manual

Contents

Magnavox 40MV336X Owner's Manual Manual pdf 19 page image

4 Use your TVSwitching on your TV and putting it in StandbymodeRemote ControlTVTo Turn the TV On from Standby or Off to Standby● Press B on the Side panel or the Remote Control.Note(s)● Energy Consumption contributes to air and water pollution. When the AC Power Cordis plugged in, your TV consumes energy with a very low Standby Power Consumption.Adjusting VolumeRemote ControlTVTo decrease or increase Volume● Press VOL J / K on the Side panel or press VOL + / – on the RemoteControl.VOL J (–) : Volume DownVOL K (+) : Volume UpTo mute or unmute sound● Press D on the Remote Control to Mute the sound.● Press D again on the Remote Control or VOL + / – to recover theoriginal sound.Switching ChannelsTVRemote ControlTo Select Channels by using CH H / I or CH + / –● Press CH H (Up) / I (Down) on the side panel or press CH + / – onthe Remote Control.To Select Channels by using the NUMBER buttonsDigital TV Operation● For Digital channels, press a number followed by a dot “•” and thecorresponding sub channel number.– When selecting Digital channel 11.1Be sure to press • before entering the subchannel number.Cable / NTSC (Analog) TV Operation– When selecting Cable or Analog channel 11Press PREV.CH to return to the previously viewed channel.Note(s)● To Select the non-memorized channels, use the NUMBER buttons.● Channel not available or No signal will appear on the TV screen after the subchannelbroadcast is over.● Audio only message will appear on the TV screen, when you receive only sound signal.19 .EnglishContinued on next page.