Magnavox 55ME314V Owner's Manual

Also see for 39ME313V: Owner's manual Owner's manual Owner's manual Owner's manual Owner's manual

Magnavox 55ME314V Owner's Manual Manual pdf 24 page image

SetupBefore you begin:Make sure the Unit is connected to Antenna or Cable.1 Press MENU and use H I to select Setup, then press OK.AntennaAdd channelsChannel listAutoprogramUSBLanguageFeaturesSetupSoundPicture2 Adjust the following items.AutoprogramBe sure the RF cable is correctly connected to this Unit and you areregistered with your Cable TV provider when you Install Cable channels.1 Use H I to Select Autoprogram, then press OK.● If you run Autoprogram when you have Locked Channels, aMessage appears asking to enter your PIN. Enter your Child LockPIN in order to Complete the Installation. (Default PIN code is 0,0, 0, 0.) You need to reset or set the Channel Lock again after theInstallation.2 Use H I to Select an appropriate Option, then press OK.– When Antenna is selected, the TV Detects Any Off-the-AirAntenna Signals. It searches for ATSC (Digital) and NTSC(Analog) Channels available in your Area.– When Cable is selected, the TV detects signals supplied byCable. It searches for DTV, Analog TV and Cable channelsavailable in your area.CableAntennaBackANTENNA INOrCableAntennaSelect your signal source.LanguageFeaturesUSBSetupSoundPicturethan 20 minutes to complete.Auto programming may take moreAuto program will rescan all channels.Exit6 chAnalog channels10 chDigital channels75%to complete.Auto programming may take more than 20 minuteschannels.Please wait while the system is scanning forAutoprogram● When the Scanning and Memorizing of Available Channels isCompleted, the Lowest Memorized Channel will be Displayed.Note(s)● After setting Autoprogram, using CH + / – skips unavailable channels Automatically.● If you are not receiving a signal from your Cable service, contact the Cable provider.● If you press B or MENU during Autoprogram, the Setup of TV channels will be Cancelled.● Even if Autoprogram is completed, the channel setting will be lost if the AC Power Cordis unplugged before the Unit goes into Standby mode by pressing B.● The PIN Code will be required Once you set a PIN code in the Child and Ratings Lock.L p. 27● If you want to change your PIN code, follow the instruction for Change PIN. Lp. 29Channel listThe channels selected here can be skipped when selecting the channelsusing CH + / –.Those channels can still be selected with the NUMBER keys.1 Use H I to select Channel list, then press OK.2 Use H I to select the channel you want to remove, then pressOK.DTVDTVDTV11.111.211.3BackWatch / SkipCh Selectkey selection.Highlight channels for Ch Up/DownUSBLanguageFeaturesSetupSoundPicture● The channel display for the removed channel darkens. You will notbe able to select the channel again using CH + / –.● To reactivate a removed channel, use H I and press OK. Theregistered channels are highlighted.● When you remove a main channel, its subchannels are removedas well.Note(s)● The channel with DTV indicated on the display is ATSC. Otherwise the channel is AnalogTV (NTSC).24 .EnglishContinued on next page.