Magnavox 55ME314V Owner's Manual

Also see for 39ME313V: Owner's manual Owner's manual Owner's manual Owner's manual Owner's manual

Magnavox 55ME314V Owner's Manual Manual pdf 34 page image

7 Useful tipsFAQQuestion AnswerMy Remote Control doesnot work.What should I do?● Check the Antenna or Cable Connection to the Main Unit.● Check the Batteries on the Remote Control.● Re-insert the Batteries with their Polarities (+/–) as indicated.● Check if there is an obstacle between the infrared sensor window and the Remote Control.● Test the IR Signal Output use IR Signal Check. L p. 36If okay, then possible Infrared Sensor trouble.● Aim the Remote Control directly at the infrared sensor window on the front of the Unit.● Reduce the distance to the Unit.● When there is an infrared-equipped device such as PC near this Unit, it may interrupt the Remote Control signal on thisUnit. Move the infrared-equipped device away from this Unit, change the angle of the Device's infrared sensor or TurnOff the infrared communication function.How come the Initial Setupappears every time I TurnOn this Unit?● Connect the RF Coaxial Cable directly to this Unit and run the Initial Setup.● Make sure to complete the Initial Setup before the Unit goes into Standby mode.Why can I not watch someRF signal TV Programs?● Autoprogram must be completed when you Set Up the Unit for the First time or Move it to a location where previouslyunavailable channels are broadcast.● Make sure Autoprogram has been completed. L p. 24● The selected channel may not be broadcasting.● When Autoprogram is interrupted and not completed, some channels will not be received. Make sure to complete theAutoprogram. L p. 24● The selected channel cannot be viewed by the Child and Ratings Lock setting. L p. 27● The Unit requires some kind of Antenna Input. An indoor Antenna (Digital or VHF / UHF), an External Antenna (Digitalor VHF / UHF) or an RF Coaxial Cable from your wall Cable / Satellite Set-top Box needs to be plugged into the Unit.How come there is noimage from the ConnectedExternal Devices?● Check if the correct Input mode is selected by pressing SOURCE or using CH + / –. Refer to Watching Channels froman External Device. L p. 18● Check the Antenna, Cable or other Input Connection to the Unit.● When using the Component Video Connection check that the Green (Y), Blue (Pb/Cb) and Red (Pr/Cr) connectorsare connected to their corresponding colored jacks on the Unit.When I enter a channelnumber, why does it changeAutomatically?● Many Digital channels have alternate channel numbers. The Unit changes the numbers Automatically to the ones signifyingthe Broadcasting Station's channel number. These basic numbers used for the previous Analog Broadcasts. (e.g., InputDigital ch# 30 Automatically changes to Digital ch# 8.1)Why are captions notdisplayed Entirely?Or why are captionsdelayed behind the dialog?● Closed Captions that are delayed a few seconds behind the actual dialog are common for Live broadcasts. Most captioningproduction companies can display a dialog to maximum of 220 words per minute. If a dialog exceeds that rate, selectiveediting is used to insure that the Closed Captions remain up-to date with the current TV screen dialog.How can I set the clock? ● There is No clock function on this Unit.My PIN code no longerworks, how can I change theChild Lock setting?● If a Power failure occurs for longer than 10 seconds the child lock setting is retained, but the PIN code is reset to thedefault code 0000. Refer to Child and Ratings Lock. L p. 2734 .EnglishContinued on next page.